Trying to pause printing so i can leave the house

Turned the heat off in pronterface and then flipped off the power supply.

Anybody have any luck doing this?

I am printing z wobble isolators with the last of my white PLA and don’t have enough to start over with.

In album


Shut the printer off at this point. Waiting to see how it works out…


Not much filament left.

2 Replies to “Trying to pause printing so i can leave the house”

  1. I think you can get pronterface to report which line it's on after you've paused it. write that line down, then you should be able to turn it all off, and restart it from that line later. 
    I've never tried it myself…

  2. I think you can get pronterface to report which line it's on after you've paused it. write that line down, then you should be able to turn it all off, and restart it from that line later. 
    I've never tried it myself…

Leave a Reply