I rebuilt the extruder on my Delta #RepRap again

I rebuilt the extruder on my Delta #RepRap again. Trying different things to find something that works for me. This is a cable-laced short bowden tube with no 'real' connectors. Quick and dirty, but it seems to be working well so far.

In album Repaired stubby bowden tube

The cable lacing is where the hold-it-all-together should happen. This is with Spectra fishing line. Same as I used for the drive-line. Low stretch. Should keep the two halves from being pushed apart.

Boom! Wonderful printing all of a sudden.

Installed. The idea is to balance the weight of the motor over the effector so the printer doesn’t have to sling all that weight around.

I used some self vulcanizing rubber tape to try to get some traction on the tube. It should also stiffen up the joints a bit so there is less flex at either end and more in the middle.

This is the prior iteration. The nylon kept wanting to stretch so I kept twisting the extruder around to tighten up the cable lacing. 2.5 full turns here! The nylon also dug into the plastic a bit as well.

I stood up at a wedding last weekend with my oldest daughter as the flower girl.

I stood up at a wedding last weekend with my oldest daughter as the flower girl.
I didn't take many photos, but here are a few of what I took.

In album Reed Wedding

The flower girl…

Bella getting her hair done up the night before so she will be the prettiest flower girl in the morning.

Hamming it up for the camera.

I think he needed to keep the flowers for the wedding…

A groomsmen and the groom decorating the gazebo.

Flower boy? Not sure if the flower petals improve the photo or not.

White shoes, the only bare patch of dirt for a quarter mile… of course she is going to walk through it!

Flower girl and ring bearer.

Really… it’s wrong. What’s wrong with the water?

May I interest you in a glass of water?

Happy bride…

Legos!

The bride

Tuckered out baby. Nap time!

Toss the Bouquet