I tried using my laser engraver to strip paint and mark the metal.

The paint stripping worked remarkably well.

I also tried using some dry moly lube as an engraving agent. This also works well. The laser can't touch metal, the metal acts like a mirror unless much more powerful than I have.

In album 1/22/17

Using the laser to strip paint.

One pass doesn’t do a great job, but the 2nd pass does.

I did a test with a quarter of the tin at different number of passes. Top is 4, bottom is 1 pass. There is a cut across just to check the pass count.

Two passes at this speed and power.

I burned the tin to darken it. I also used moly lube to label it. I accidently labeled the wrong side.

I wrote a bit of OpenScad to laser cut a leather pen case

https://github.com/creuzerm/openscad-projects/tree/master/laserable/Pen%20Case

I cut it and am looking at it and while it looks good, I think it is flawed.

The little round holes for stitching are easy to tell a robot to make. However, I am thinking that they actually overly weaken the seam.

I didn't look for the wisdom in the old fashioned hand tools.

The best stitching punches put little slits at a diagonal to the seam. I think this is actually very clever. This directs any tearing forces away from the next stitch hole and also not directly towards the edge.

So back to the drawing board so to speak and change the code to cut slits.

Than time to test and see if the slits really do make for a stronger seam.

In album 1/9/17