Some heat generation numbers for a day that’s ~10 degrees F outside, 25 degrees in my uninsulated garage: Full overcast but bright – 40 degree air coming out of the panel (+15) Partial sun, enough for shadows – 60 degree air coming out of the panel (+35) Full sun, 90+ degree air coming out of …
Tag Archives: degree
I am working on a hexagon shaped picnic table for the office
Hexagon shapes are a pain to cut. Lots and lots of 30 degree cuts. They would be so much easier with a miter box. I should be able to finish it tomorrow night. Google+: View post on Google+ .
Marking and Cutting the Tenons
I marked the Tenon cut marks all the way around. I also made sure to X off the scrap on both ends at the same time so I didn’t accidentally end up with a 90 degree twist in my tenons. I cut the ends on my miter box down to the lines. It really helps to cut …