I think I figured out my 'cable chain' that I will use to the hot end on my delta. This is a piece of 3mm PLA. I will cable lace the stepper and hot end wires to the plastic. The filament will run down the center. View this post on Google+
Author Archives: mike
I finally got my Delta RepRap moving correctly
I've been fighting it for over a year. First it was a bad RAMPS board/pololu drivers. I replaced that with a SmoothieBoard (which is awesome by the way) and then it took me a month to figure out that my bed center, homing and gcode combo is causing the machine to calculate out-of-bounds which gives …
Continue reading “I finally got my Delta RepRap moving correctly”
A couple of birthday photos…
A couple of birthday photos… In album 2014-04-27 View this post on Google+
My little one climbed into big sister's bed
So I tucked her in, with some of the toys. View this post on Google+
Who needs The Club when you have a Cyborg Beast!
Who needs The Club when you have a Cyborg Beast! In album 4/13/14 View this post on Google+