With the recent heat wave, they seem to covet my AC and have invaded.
Instead of getting into the hot car, driving to buy a swatter, I printed one. I found it on Thingiverse – http://www.thingiverse.com/thing:9518 .
Took about 3 hours to print in white PLA at .1mm layer height.
I think it's pretty awesome!
But did it shatter upon use?
But did it shatter upon use?
nope.
But It's got a week spot where the stick mounts to the swatter & it is prone to delaminating at that spot.
nope.
But It's got a week spot where the stick mounts to the swatter & it is prone to delaminating at that spot.
Duct tape for the delaminating issue 🙂
I have some white electrical tape. Works about the same in this instance.