It looks like operation z-wobble removal is a success! I printed out a tall, thin…

It looks like operation z-wobble removal is a success! I printed out a tall, thin print with what’s left of my white to test the fix. http://www.thingiverse.com/thing:28690

As you can see, it’s MUCH better than it used to be. I had some issues that I think are thermal in nature as there are a few layers that didn’t bond well.

I blame http://www.thingiverse.com/thing:20147 for the dramatic improvement on my printer.

In album


Printing a cell phone battery holder I designed as a test print.


Looks pretty good.


I have some very fine lines, but they appear to be layer lines and not z wobble lines.


There was a week layer. Not sure if the printer z-lifted and didn’t settle back down or if I had a cool layer and it didn’t bond well.


Annoying how I can only do 4 photos at a time.

Leave a comment

Your email address will not be published. Required fields are marked *

WordPress Appliance - Powered by TurnKey Linux