It looks like operation z-wobble removal is a success! I printed out a tall, thin print with what’s left of my white to test the fix. http://www.thingiverse.com/thing:28690 As you can see, it’s MUCH better than it used to be. I had some issues that I think are thermal in nature as there are a few layers …
Category Archives: RepRap
I printed some z wobble minimisers and installed them tonight
http://www.thingiverse.com/thing:20147 I had to leave half way through the print, so I paused the job and powered down the heaters. The print finished ok when i powered the heaters back up, leaving a big blob where the nozzle had sat. Need to lift the nozzle off of the part or something. Last time I tried …
Continue reading “I printed some z wobble minimisers and installed them tonight”
Trying to pause printing so i can leave the house
Turned the heat off in pronterface and then flipped off the power supply. Anybody have any luck doing this? I am printing z wobble isolators with the last of my white PLA and don’t have enough to start over with. In album Shut the printer off at this point. Waiting to see how it works …
Continue reading “Trying to pause printing so i can leave the house”
The force is strong in this one
I printed a large Yoda < http://www.thingiverse.com/thing:12288 > for a coworker in white PLA. Aspects of it make this my best print yet, and yet it looks pretty bad in some ways. First, it took 3 different slices and about 10 starts before I could get Yoda to stick to the bed. Lots of issues, …
black is current carraige bits, red is now, yellow is air flow.
black is current carraige bits, red is now, yellow is air flow. View this post on Google+ .