I thought long and hard about how I am going to cut in the nuts. The instructions said to use a 3/8ths inch drill bit. Then I saw a spade bit in the store, and thought that’s perfect. It will give me a nice flat bottom. So, I use a spade bit to drill the …
Category Archives: kayak
Folded up PakYak frame.
The whole boat folds up into this little package of wood, aluminum, nuts and bolts. It isn’t folding too tight because I can’t be bothered with the details in the directions. Flat Head Screws, not pan head screws. Oh well, I got some now, so lets see what it looks like with the correct hardware. Isn’t …
Rough Assembled Frame
Tada, the assembled boat frame. Now I get to take it all apart, round the corners that need to be rounded, bevel the edges that need to be beveled, counter sink the holes that need to be countersunk, cut in all my nuts, sand, and urethane the frame. Fhew, that sounds like work to me! …
Both halves of the Kayak side by side
I laid out all the pieces on the ground so I knew where the longer and short stringers went together. I was really confused for a moment, because I was short a stringer, and then I remembered, I had broken one. So I cut a new stringer to size. I tried assembling all the little wooden …
Cutting the 4inch bar stock in half.
I need to cut this in half lengthwise. I am not really happy with how I ended up doing it. It worked, but It didn’t feel safe. I think that for the money, I am just going to buy a bit of 1″ flat stock and not worry about my fingers. Doesn’t this look like …