Julie and I where in the laBOREtory tonight. I showed her the fish tank on the floor. She loved it. First time she paid it any attention. And straws. She loves straws. View this post on Google+
Tag Archives: fish
I was playing around last night with making my Rostock to use the full length of…
I was playing around last night with making my Rostock to use the full length of the smooth rods even though my belts where not long enough. I didn't want to mess with the spindles used for the Spectra line mechanism. I came up with a hybrid. It uses the belts for the drive side, …
Continue reading “I was playing around last night with making my Rostock to use the full length of…”
Delta RepRap using both belts and Spectra fishing line
I have this new RepRap 3D printer that came to me half assembled, sans electronics. It had been running, but got pirated for parts to make another Prusa.
There is a lot more room on the smooth rods for it to get taller. I just need to make a belt stretcher (I am too cheap to buy longer belts).
I have some fishing line I picked up on clearance a few years ago – $6. It just so happens to be the 65lb Spectra line that people are using to string up their Kossels.
So I decided to use both. Belts for the drive and line for the ‘idler’ side.
I think I invented something
A laminar flow pipe reducer for a pump housing. At least, a little bit of Google searching hasn't shown me another. I am trying to find a cheaper way to heat the 75 gallon aquaponics system in the basement. It's really running closer to 125 gallons of water with a LOT of surface area. This bleeds heat …
Watercooling my MakerGear Prusa RepRap
I’ve been fighting with printing 1.75mm PLA. The thicker brass in the hot end causes the heat to creep up more and make the ‘melt zone’ so long and sticky that the printer jams up. So, I fixed this issue. With one of my aquariums. I am now water cooling my hot end.