I was looking through ThingiVerse and came across a printable stencil set http://www.thingiverse.com/thing:17346 This got me to thinking. By making a stencil that is something like 1/8th inch thick, you can make the bridges only 1/16 inch thick and when you use the stencil, face them away from the surface. The spray paint should overspray …
Continue reading “I was looking through ThingiVerse and came across a printable stencil set http:/…”
I am seriously excited about getting my 3d printer. It’s been a week since I ordered it, so 1-2 more weeks according to the confirmation email I got. The printer can print in ABS. This can be a stinky plastic to print, but I’ve plans for making a fume hood for the printer that vents …
Continue reading “3d printer ideas for custom aquaponics fittings”
I’ve been following the RepRap movement (DIY Rapid Prototyping machines also known as 3d printers) for at least 3 years now. MSOE had several of the commercial units that I drooled over frequently, but never got a chance to dig deeper into. Thus, I’ve been aware of the technology for nearly 15 years now. But it’s …
37 degrees outside and 43 degrees inside the garage when the photo was taken. Too bad the garage is un-insulated and has to start over every morning for warming up. One of these days that will be fixed… In album 115 degrees coming out of the Solar Hot Air Panel 115 degrees with a small …
Continue reading “115 degrees from the Solar Hot Air Panel on the garage”
I was working on some of my hand forged Settlers of Catan pieces on my UNiMAT mini lathe tonight. I mainly wanted to flatten the bottom of the pieces so they would sit flat on the board. I also tried to machine the roof of one just to see if I could do it. I …
