It charges via a barrel jack. It has USB OTG. I must connect it to an arduino. I must connect it to my RepRap! I must make a USB OTG cable. I grabbed an old USB charger and started to work with that. I broke one of the pins off. DOH! So I attacked a …
Continue reading “My wife bought me a $50 black Friday seven inch Android tablet”
I have this new RepRap 3D printer that came to me half assembled, sans electronics. It had been running, but got pirated for parts to make another Prusa.
There is a lot more room on the smooth rods for it to get taller. I just need to make a belt stretcher (I am too cheap to buy longer belts).
I have some fishing line I picked up on clearance a few years ago – $6. It just so happens to be the 65lb Spectra line that people are using to string up their Kossels.
So I decided to use both. Belts for the drive and line for the ‘idler’ side.
A laminar flow pipe reducer for a pump housing. At least, a little bit of Google searching hasn't shown me another. I am trying to find a cheaper way to heat the 75 gallon aquaponics system in the basement. It's really running closer to 125 gallons of water with a LOT of surface area. This bleeds heat …
I can’t call this a heat exchanger, as it doesn’t exchange any heat. It just sheds some of the heat from the dryer duct into the room. I am trying to keep some of the heat I paid to create, in the house, where I tend to hang out when it’s cold outside. I know …
Turned the heat off in pronterface and then flipped off the power supply. Anybody have any luck doing this? I am printing z wobble isolators with the last of my white PLA and don’t have enough to start over with. In album Shut the printer off at this point. Waiting to see how it works …
Continue reading “Trying to pause printing so i can leave the house”
